1. The groove size of the ring-mounted rubber seal is out of tolerance, especially when the depth size is too large, the compression deformation of the imported O-ring after installation is insufficient and the sealing ability is affected. Generally, the compression deformation of ring-type rubber seals after installation should be between 18% and 22%.
2. The nominal size of the ring-type rubber seal is too different from the actual installation size, and the O-ring is formed to work under the condition that the section size is reduced after stretching, resulting in insufficient compression deformation and leakage.
3. When the sealing ring is installed, the ring-shaped rubber seal is scratched and leaks due to the lack of smooth chamfering or rounding at the entrance of the sealing surface.
4. The material of the ring type rubber seal is not suitable for the sealing medium and will fail after being eroded.
5. The ring-shaped rubber seal will age and deteriorate after being used for too long, and the elasticity will decrease and then fail. Therefore, the ring-shaped ring is generally replaced when the equipment is overhauled.
