The O-shaped rubber sealing ring, which plays a sealing role in various mechanical equipment, generally requires that its rubber material must have good elasticity, low compression set and aging resistance. In addition, different mechanical equipment and sealing media are different, and the rubber compound is also required to have some special properties.
In the hydraulic system, the rubber compound is required to have good oil resistance, temperature resistance, low compression set and certain tensile strength. As a dynamic seal, in addition to the above requirements, the wear resistance and tear resistance of the compound should also be considered. Seals used in vacuum environments require good air tightness and low volatility.
Seals used for special media require small changes in the volume and hardness of the rubber in the medium, and little changes in other properties. In short, formula design should be comprehensively considered according to specific working conditions, medium types, use temperature, working pressure and application state. From the technical requirements and application of O-ring seals, nitrile rubber consumes the largest amount of rubber, followed by fluorine rubber, neoprene rubber and silicone rubber, and acrylate rubber and ethylene propylene rubber are used in relatively small amounts.
According to the different pressures in the sealing system, O-ring sealants with different hardness are designed respectively. If the pressure is high, high-hardness rubber should be used, and if the pressure is low, medium-hardness or low-hardness rubber should be used. In the past, not enough attention was paid to the hardness of the rubber compound used for O-ring seals, and the use was confusing. Many problems occurred due to improper hardness matching, such as poor sealing performance of seals and short service life.
According to the analysis, some are the product quality problems of the manufacturers, but there are also many early damages or leakages caused by poor consideration of the hardness of the rubber compound. In order to improve product quality and service life, the hardness of the rubber compound has been serialized in the national standard. For example, the nitrile rubber used in the hydraulic system, except for special requirements, has four hardnesses: 60°±5°, 70°±5°, 80°±5°, 88°±5° (Shore A) Hardness level to suit different pressure requirements. Generally, 60-70 is low hardness, 80 is medium hardness, and 88 is high hardness. When the sealing pressure is in the range of 30-60MPa, the hardness of the O-ring seal is 85-90.
